Adding a Disc, a Folder or a File

To add a drive, folder or file use the -AddNew (-add) key:

 

 

 

Path to the drive, folder or file to add must be passed in the -FileSystemPath (-fsp) parameter:

 

 

 

Path to the parent folder in WinCatalog may be set in -CatalogPath (-cp) parameter:

 

 

 

If the -CatalogPath is not set or incorrect, new element (drive, folder or file) will be added to the root Catalog folder.

 

Use the key -CreatePathIfNotExist (-cne), if you want to create virtual folder from the -CatalogPath parameter:

 

 

 

Use the key -ProfileId (-pid) with the numeric profile ID to select the scanning profile:

 

 

 

Where NN is the numeric value of the scanning profile ID. The ID of the scanning profile may be found on top of the General Scanning Page for each scanning profile (see the screenshot below):

 

 

 

 

Start WinCatalog, open the catalog file "d:\my catalog.w3cat", add drive E:\ to the root catalog folder. Please notice: the path ends by two slashes if you use quotes (the backslash at the end is interpreted as the start of an escape sequence, so single slash before the quote character will be interpreted as just a quote). The backslash at the end is not necessary - WinCatalog will add a backslash, so it is enough to pass just `"E:"`.

 

 

Start WinCatalog, open the catalog file "d:\my catalog.w3cat", if not exists, create the "Catalog\Folder\Sub Folder" virtual (blue) folders, add the "Folder" from drive "E:\" into "Catalog\Folder\Sub Folder".